WEBVTT

00:00:00.000 --> 00:00:04.000
Create a configuration, open an XML preset, or resume a project.

00:00:04.000 --> 00:00:08.000
Start with an empty project, with no devices or routes.

00:00:08.000 --> 00:00:12.000
Open the device bank and browse the available templates.

00:00:12.000 --> 00:00:16.000
Filter the bank, choose the CL3 and add it to the project.

00:00:16.000 --> 00:00:19.000
The CL3 is now ready to patch.

00:00:19.000 --> 00:00:23.000
Open the Studio XML preset. The project contains two devices.

00:00:23.000 --> 00:00:27.000
Add a second XML preset to the open configuration.

00:00:27.000 --> 00:00:31.000
After merging, all three devices are in the same project.

00:00:31.000 --> 00:00:35.000
The RX list shows the source of each subscription.

00:00:35.000 --> 00:00:39.000
Add a route from the console to the rack.

00:00:39.000 --> 00:00:44.000
The TX names change. Subscriptions follow the new names.

00:00:44.000 --> 00:00:48.000
Hover over Micro-01. Use the small square to extend the series.

00:00:48.000 --> 00:00:49.560
Drag the square to the fourth channel.

00:00:49.560 --> 00:00:55.560
Micro-01, Micro-02, Micro-03, Micro-04. All four routes are still present.

00:00:55.560 --> 00:00:59.560
FLIP TX ⇄ RX flips the routing view.

00:00:59.560 --> 00:01:03.560
Start a network session. The devices shown here are simulated.

00:01:03.560 --> 00:01:08.560
The grid shows active subscriptions. Green for unicast, blue for multicast.

00:01:08.560 --> 00:01:13.560
The missing receiver remains visible, with its planned routes shown in grey.

00:01:13.560 --> 00:01:17.560
The receiver returns in the simulation. The project stays available.

00:01:17.560 --> 00:01:22.560
Check how project devices match the devices on the network.

00:01:22.560 --> 00:01:29.560
Select the differences, choose a direction for each, and set the order.

00:01:29.560 --> 00:01:37.560
The network diagram shows the project’s devices and their connections.